Download Manual  
Moxi MC3

Programming Codes:

Select the manufacturer of your device from the list. The codes will appear below the list boxes.

Not all manufacturer brands listed may be compatible with this remote.
TV:         
 

Audio Device:  
 
 

Programming the TV with Codes

You can program your remote to control TV power and volume, as well as power, volume and mute for an audio device.

Some older devices may not be supported. If the device doesn't respond to any code, use its original remote to control it.

  1. In front of the TV, press and hold the Moxi and OK buttons simultaneously on your remote until the LED at the top of the remote blinks twice.
  2. Using the number buttons on the remote, enter one of the codes for your device that you wrote down or from the menus above. When you enter a code correctly, the LED blinks twice. If it blinks once, the code was invalid. Try entering the code again. If the code was correct for your device, then the device will turn on or off.
  3. If the TV or device does not respond, start over using another listed code. Repeat until successful, or see Programming by search.

Programming the TV by Search

If your TV or audio device isn't listed, or the codes above don't work, try programming by search. Programming by search allows the remote to cycle through codes to find one that works with your TV or audio device.

p>

Some older devices may not be supported. If the device doesn't respond to any code, use its original remote to control it.

  1. In front of the device, press and hold the Moxi and OK buttons simultaneously on your remote until the LED at the top of the remote blinks twice.
  2. Slowly press the ch+ button repeatedly to advance through the code list until the device turns on or off.
  3. Once the device responds, press the OK button to set the current code.
  4. Press the power button on the remote. If the device doesn't respond, repeat the previous steps pressing the ch+ button more slowly.

Programming the Moxi Remote to the Moxi Spectrum Receiver

The remote will need to be programmed for any of the following to operate it: Moxi MP12, BMC9012, BMC9012F or BMC 9022. Use the following steps to program the remote for your Moxi Spectrum Receiver.

  1. Turn on the receiver.
  2. Press and hold the Moxi and OK buttons on the remote until the red LED at the top of the remote blinks twice.
  3. After the red LED has blinked twice, release both buttons.
  4. Using the numbers on the remote, enter 0, 0, 4. The red LED at the top of the remote will blink twice.
    Note: Once the LED blinks twice at the end of step 4, try using the remote to change channels or use other functions of the receiver.

Additional Programming Features

To view which device you've programmed for a specific remote control key:

  1. Press the Moxi button and OK buttons.
  2. Press the info button, and then press any one of the four programmable keys (such as, vol+/-, mute, or power).

The LED light for the power button blinks back the code, blinking the number of times equal to the first digit of the code, then pausing before blinking the number of times equal to the second digit in the code, and so forth. For the digit 0, the LED blinks rapidly several times.

The default settings for the vol+/- and mute buttons control the TV when there is not an audio device programmed. When an audio device is programmed, then the default settings for the vol +/- and mute buttons are controlled through that device.

To reset your remote to the original factory settings:

Press the Moxi plus OK buttons simultaneously and hold until the LED light blinks twice, and then press clear, clear, clear.

Note: Be aware that this will erase all settings, previously recorded programs and any future recordings scheduled on the receiver.